sE Electronics sE4400 Condenser Microphone Pair

sE Electronics sE4400 Condenser Microphone Pair

Two microphones are factory-matched for a virtually identical frequency response and a consistent stereo image. Each offers four selectable pickup patterns.

The hand-crafted 1-inch brass condenser capsule uses dual gold-sputtered Mylar diaphragms. Its smooth response recalls classic condenser microphones.

A metal body, metal switches and spring-steel grille are built for studio and touring use. The circuit uses discrete electronic components.

The microphone requires 48 V phantom power, supplied through a balanced cable with XLR connectors at both ends. Phantom power cannot pass through TRS connectors.

Main Features

• The -10 dB and -20 dB pads reduce the microphone output level, helping prevent audio-interface input overload when recording loud sources.
• 40 / 80 Hz low-cut settings reduce rumble and excessive bass during close miking. The filter can also be bypassed.
• The shock mount isolates vibrations and footfall noise transmitted through the stand. Its suspension and the flat microphone body make close placement against drums or guitar cabinets easier.

Technical Specifications

• Capsule: 1-inch condenser, dual gold-sputtered Mylar diaphragms
• Polar Pattern: cardioid, hypercardioid, omnidirectional, figure-8
• Frequency Range: 20–20000 Hz
• Sensitivity: 25 mV/Pa (−32 dBV)
• Max SPL: 137 / 147 / 157 dB with the pad set to 0 / -10 / -20 dB (0.5% THD)
• Equivalent Noise Level: 13 dB(A)
• Dynamic Range: 124 / 134 / 144 dB with the pad set to 0 / -10 / -20 dB
• Signal-to-Noise Ratio: 81 dB
• Low-Cut Filter: 40 / 80 Hz, 6 dB/oct., switchable
• Attenuation Pad: 0 / -10 / -20 dB
• Impedance: 22 Ω
• Recommended Load Impedance: >1 kΩ
• Power: 48 V phantom (P48, IEC 61938)
• Current Consumption: 3.7 mA
• Output: 3-pin XLR (male)
• Dimensions (W × H × D): 58 × 146 × 29 mm per microphone
• Weight: 290 g per microphone

What’s Included

• 2 × sE Electronics sE4400 condenser microphones
• 2 × shock mounts with thread adapters
• 1 × stereo microphone bar
• 1 × metal case

The stereo bar mounts both microphones on one stand. After the session, the microphones and their shock mounts can be stored in the supplied metal case.

Who Is It For

For stereo recording in the studio or on stage, including piano, acoustic instruments and drums. The microphones can also be used separately for vocals, guitar cabinets, strings and wind instruments.

Can’t find the sE Electronics product you are looking for?

Contact us: info@stageiq.lt or +370 636 55536.