Electro-Harmonix LPB-3 Effects Pedal
Pay in instalments with ESTO
Couldn't load pickup availability
Description
Description
Electro-Harmonix LPB-3 Effects Pedal
The analog circuit can boost a mono signal by up to 33 dB. An active three-band EQ with parametric midrange control is housed in a compact Nano enclosure.
Bass and treble can be boosted or cut independently. For the midrange, you can select the center frequency, level and bandwidth, shaping the tone before increasing the overall volume.
Use the pedal for a clean boost, to drive an amplifier harder, or to raise an instrument signal to line level in a recording setup. Connect the instrument to INPUT and route OUTPUT to a suitable amplifier or mixer input.
Internal ±15 V power rails provide more headroom before clipping. This is an internal operating voltage and must not be supplied to the external power connector.
Main Features
- PRE-GAIN adjusts input gain over 0–20 dB before the EQ, while BOOST sets the overall output volume.
- MAX selects either 20 dB or 33 dB of maximum gain from input to output. The 20 dB setting allows greater dynamics; 33 dB can drive an amplifier harder.
- MID FREQ sets the midrange center frequency from 240 Hz to 3.3 kHz. MID LVL boosts or cuts this band, with a flat response at its center position.
- The LOW setting of Q affects a broader frequency band. HIGH focuses the midrange adjustment on a narrower range.
- TREBLE boosts or cuts high frequencies above 3.2 kHz, with a flat response at the center position.
- BASS adjusts low frequencies below 240 Hz. Its center position leaves the bass response flat.
- When boosting EQ bands, reducing PRE-GAIN helps prevent clipping. When cutting bands, increasing PRE-GAIN can restore volume.
- A switch under the bottom cover selects TRUE bypass or BUFFERED bypass through an op-amp buffer. The factory TRUE position connects INPUT directly to OUTPUT, bypassing the circuitry.
- The footswitch engages or bypasses the effect. The LED lights when the effect is active and goes out in bypass.
Technical Specifications
- Input Impedance: 1 MΩ
- Maximum Input Level: +20 dBu
- Output Impedance: 660 Ω
- Maximum Output Level: +22 dBu
- Power: 9 V DC, center negative
- Current Draw: 120 mA
- Recommended Power Adapter Rating: at least 150 mA
- Maximum Permitted Voltage: 12 V DC
- Included Power Adapter Output: 9.6 V DC, 200 mA (Electro-Harmonix 9.6DC-200)
- Dimensions (W × H × D): 69.85 × 53.34 × 114.3 mm
This model does not use batteries. An external power adapter is required.
What’s Included
- 1 × Electro-Harmonix LPB-3 Effects Pedal
- Region-appropriate power adapter
Who Is It For
For setups that need an instrument level boost together with focused tonal adjustment. Highlight a solo, drive an amplifier harder or adapt the signal level for recording, using the parametric midrange band to target the part of the tone you want to change.
Can’t find the Electro-Harmonix product you are looking for?
Contact us: info@stageiq.lt or +370 636 55536.





