DPA MMP-ES Active Microphone Cable
Couldn't load pickup availability
Aprašymas
Aprašymas
DPA MMP-ES Active Microphone Cable
DPA MMP-ES is an active microphone cable with an integrated preamp.
The preamp section sits in a 12 mm housing and attaches to a DPA modular pencil microphone capsule. This small housing suits suspended or low-profile table mounting.
The 3 m cable leaves the capsule interface from the side, allowing it to run along a nearby surface. MMP-ER instead has rear entry.
A 3-pin XLR male connector terminates the cable. Its active circuit requires P48 phantom power and provides an impedance-balanced output.
Main Features
- Side cable entry helps route the cable in a low-profile table or instrument microphone setup.
- The modular interface allows a suitable DPA pencil microphone capsule to be selected.
- The integrated preamp uses active impedance balancing to help reject radio-frequency interference.
- The 131 dB dynamic range and 100 Ω output impedance help assess the connection to audio equipment.
Technical Specifications
- Compatibility: DPA modular pencil microphone capsules
- Preamp Housing: 12 mm
- Cable Entry: side
- Cable Length: 3 m
- Output Connector: 3-pin XLR male
- XLR Pinout: 1 shield, 2 positive signal, 3 negative signal
- Low-Frequency Cutoff (−3 dB): 15 Hz
- Noise with Shorted Input (A-weighted): 0.6 µV
- Output Voltage (RMS): 2.2 V
- Peak Output Voltage: 3.1 V
- Circuit: active, with impedance-balanced output
- Distortion (THD, 1 V RMS, 1 kHz): less than 0.2%
- Dynamic Range: 131 dB
- Output Impedance: 100 Ω
- Minimum Load Impedance: 2 kΩ
- Power: P48 phantom, 48 V ±4 V for full specifications
- Current Consumption: 3.5 mA
- Common-Mode Rejection (CMRR): greater than 40 dB
- Additional Cable Drive Capability: up to 100 m
- Weight: 91 g
- Color: matte black
- Operating Temperature: −40 °C to 45 °C
- Relative Humidity: up to 90%
What’s Included
- 1 × DPA MMP-ES active microphone cable
Who Is It For
For a modular DPA capsule in a suspended or low-profile table or instrument microphone where side cable entry and XLR are required.
Can’t find the DPA product you are looking for?
Contact us: info@stageiq.lt or +370 636 55536.

