DPA 4018VL-B-B01 Vocal Microphone

DPA 4018VL-B-B01 Vocal Microphone

A linear frequency response reproduces vocals naturally, leaving the sound engineer free to shape the final sound. This is the wired d:facto version with an XLR handle.

The supercardioid pattern attenuates other stage sources. A wide acceptance angle gives the performer room to move in front of the microphone, with 3 dB attenuation at ±60°. DPA specifies at least 9 dB side rejection.

The proximity effect increases bass when singing close to the microphone. Its response is tuned at 12 cm, and DPA recommends keeping about 2 cm between the lips and grille to avoid acoustic distortion.

The modular design allows the capsule or adapter to be changed. For wireless use, a DPA adapter matched to the particular transmitter replaces the wired handle, so the entire microphone need not be replaced.

The wired version requires 48 V phantom power from a microphone input or an external power supply.

Main Features

• The DUA0710 grille incorporates three-stage pop protection; its removable parts can be cleaned separately from the capsule.
• The design reduces handling noise transmitted through the microphone body.
• The DUA0703 external foam windscreen is available separately for outdoor use or stronger wind and plosives.
• DPA adapters support selected Sennheiser, Shure, Sony, Wisycom, Lectrosonics and Line6 systems; the adapter must match the specific transmitter.

Technical Specifications

• Model: 4018VL-B-B01
• Capsule Type: pressure-gradient, pre-polarized condenser
• Polar Pattern: Supercardioid
• Assembly: MMC4018VL capsule, FAADPA2B XLR handle, DUA0710 grille
• Frequency Range: 20 Hz - 20 kHz
• Frequency Response (±2 dB, at 12 cm): 100 Hz - 16 kHz
• Low-Cut Filter: permanent third-order filter at 80 Hz
• Sensitivity (±2 dB, at 1 kHz): 5 mV/Pa; -46 dB re. 1 V/Pa
• Equivalent Noise Level: typically 19 dB(A), maximum 21 dB(A), re. 20 µPa
• Signal-to-Noise Ratio: typically 75 dB(A), at 1 kHz and 1 Pa
• Harmonic Distortion: THD <1% up to 139 dB SPL peak
• Max SPL (Peak, Before Clipping): 160 dB
• Dynamic Range: typically 120 dB
• Impedance: <100 Ω
• Minimum Load Impedance: 1 kΩ
• Cable Drive Capability: up to 100 m
• Output: actively balanced, Active Drive
• Common-Mode Rejection (CMRR): >50 dB at 1 kHz
• Phantom Power: 48 V (±4 V)
• Current Consumption: maximum 2 mA
• Connector: XLR-3M; pin 1 shield, pin 2 positive signal, pin 3 negative signal
• Weight: 309 g
• Dimensions: 52 mm diameter
• Capsule Diameter: 19 mm
• Color: Black

What’s Included

• 1 × DPA 4018VL-B-B01 vocal microphone with FAADPA2B XLR handle and DUA0710 grille
• Microphone clip

Use the supplied microphone clip to mount the microphone on a stand.

Who Is It For

For stage vocals and broadcast work where a linear response leaves control of the vocal sound to the engineer. A wireless transmitter and its matching adapter must be selected separately.

Can’t find the DPA product you are looking for?

Contact us: info@stageiq.lt or +370 636 55536.